Step 8 Connect Cables - American Megatrends Enterprise-II User Manual

Step 8 Connect Cables

When connecting chassis connectors to the
motherboard, make sure to connect the
correct connector end.
Most connector wires are color-coded.
Match the color of the wires leaving the
switch or LED to the same pin on the
connector end. There may be more than one
connector with the same color-coded wires.
If so, follow the wire to the switch or
LED.
Pin 1 of all connectors is labeled on the
Enterprise-II motherboard to identify the
pin orientation when plugging in cables.
See the following graphic.
The following cables should be connected
to the motherboard:
· Reset Switch cable to J17
· Speaker cable to J13.
· Keyboard Lock cable to J14.
· Turbo Switch cable to J18
· Turbo LED cable to J19
J17 Reset Button Connector
American Megatrends Enterprise-II Motherboard User's Guide
27