Peripheral Setup,
OffBoard PCI IDE Card Uses
This option can only be selected if the Onboard IDE option is set to Disabled. You cannot set this option if using the IDE
controller on the motherboard. This option allows you to specify the PCI interrupt that the offboard IDE controller adapter
card uses. The settings are INT A, INT B, INT C, or INT D. The Optimal default setting is INT A.
Primary Master IDE Block Mode
Primary Slave IDE Block Mode
Secondary Master IDE Block Mode
Secondary Slave IDE Block Mode
When set to Enabled, these options enable multiple sector reads and writes for the primary master, primary slave, secondary
master, or secondary slave IDE drive. The settings are Enabled or Disabled. The Optimal default setting is Enabled.
Primary Master IDE PIO Mode
Primary Slave IDE PIO Mode
Secondary Master IDE PIO Mode
Secondary Slave IDE PIO Mode
These options specify the IDE Programmed I/O (PIO) mode used by the primary master, primary slave, secondary master, or
secondary slave IDE drive. The settings are Auto (AMIBIOS automatically sets the correct IDE mode), Mode 0, Mode 1,
Mode 2, Mode 3, or Mode 4. The Optimal default setting is Auto. Selecting a mode not supported by the IDE drive causes
data loss.
Super Voyager PCI-II 486 ISA Motherboard User's Guide
Continued
Cont'd
53