Brother RJ-3150 Manual page 203

RJ-3150
6. Set the media size and try a test print.
a. Open a web browser and go to "http://localhost:631/printers".
b. Select your printer's name.
c. Click "Set Printer Options" and set the media size.
e.g. If you are using 62mm tape, select 62mm.
The printer will indicate an error if the media width is too large or too small.
d. Click "Print Test Page.
Example of a test print output (62mm width)
The supported media length for continuous tape is about 100 mm.
Use the paper tool command to add a custom media size longer/shorter than 100mm.
For more information, see
Pre-required procedures
For openSUSE 10.3 or earlier
Related distributions
openSUSE 10.3 or earlier
Related products/drivers
cupswrapper printer/PC-FAX drivers
Requirement
"lppasswd -g sys -a root" command is required before the installation.
(Setting the root password is required befor you can issue this command.)
For Fedora10
Related distributions
Fedora10
Related products/drivers
P-touch/QL-Printer drivers
Requirement
SELinux configuration is required.
e.g. Set selinux "premissive mode" by the command "# setenforece 0" (superuser authorization is required)
For Ubuntu 8.04 or greater
Related distributions
Ubuntu8.04 or greater
Related products/drivers
P-touch/QL-Printer drivers
Requirement
1. "sudo aa-complain cupsd" command is required before the installation.
2. "sudo mkdir /usr/share/cups/model" command is required before the installation.
For PT-9500PC
Related distributions
Distributions that does not have "psutils" by default
"Adding a custom media size for continuouse tape (Linux®)".
197 / 237
Go to Index
Go to Index