If the label peeler is used, printed labels can be automatically peeled off their backing paper before they are fed out of the media exit. This is useful when printing large quantities of labels and apply them at an

inconsistent pace, because the peeler sensor prohibits printing the next label until it is removed from the printer.

To set the Label Peeler, please follow the steps or click on the image to play the video instructions below:

Movie: How to set the Label Peeler

[BrotherGlobalSupport] faqp00100086_000 RJ-3150 How do I set the L

*The video clip is being streamed from YouTube.

1. Push the cover open lever to open the RD Roll compartment cover.

1 Cover open lever

2. Push both sides of the label peeler towards the rear of the printer. The peeler will move up and away from the printer.

Then, fully pull out the peeler away from the printer until the

The paper can be pulled out in two stages. Be sure to pull out the peeler completely.

3. Peel off the first label of the RD Roll. Then, insert the RD Roll so that the top edge of the second label is at the same height as the top edge of the media sensor plate.

Position the label where the media sensor can detect it.

marks on the peeler are visible as shown.

137 / 237

Go to Index

How to use the buttons:

Start the video

Skip the video

Stop the video

Restart the video

Go to Index