Warnings And Cautions - American Dynamics SpeedDome Optima LT Installation Manual

Warnings and Cautions

Please review the following warnings and cautions
before you begin installation or service.
WARNINGS
WARNING!
ALWAYS USE:
•
Proper safety equipment for the
location and type of installation.
•
Proper lift equipment to reach the
installation.
•
Safety features of the lift equipment.
BE SURE:
•
Electrical power is not connected to
the dome when connecting wires.
Dome will move when power is
applied.
•
Electrical power is not connected to
nearby fixtures that you might touch
during installation.
WARNING!
The camera dome used in this
housing runs on 24Vac. DO NOT
connect line voltage to this dome.
Worldwide power requirements: A
certified limited power source is required.
North America power requirements:
This device is intended to be supplied
from a Class 2 power supply.
This installation should be made by a
qualified service person and should
conform to all local codes.
WARNING!
DO NOT install this housing in
hazardous areas where highly
combustible or explosive products are
stored or used.
SPEEDDOME OPTIMA LT INDOOR PENDANT MOUNTING STRUCTURE
INSTALLATION GUIDE
WARNING!
EU power requirements: This product
runs on 24Vac. In the EU, it is intended
to be powered from a Limited Power
Source. A limited power source is a
certified source of SELV, and if
inherently limited, with 8 amps maximum
output current, and a maximum of 100VA
available; or if not inherently limited,
fused with a maximum value of 3.3
Amps, meeting section 2.11 of IEC950,
and a maximum of 250VA available. The
power supply can be obtained through
Sensormatic or through another source
where the provider can furnish the
verification. This is required to assure
electrical safety in the product.
Stromanforderungen in der EU:
Dieses Produkt wird mit 24 V
Wechselstrom betrieben. In der EU ist es
für den Betrieb durch eine begrenzte
Stromquelle vorgesehen. Eine begrenzte
Stromquelle ist eine zertifizierte SELV-
Quelle (Schutzkleinspannung), bei
inhärenter Begrenzung mit einem
maximalen Ausgangsstrom von 8 A und
100 VA maximaler Verfügbarkeit, bei
nicht inhärenter Begrenzung mit einer
maximalen Sicherung von 3,3 A gemäß
Abschnitt 2.11 der IEC950 und 250 VA
maximaler Verfügbarkeit. Das Netzteil
kann über Sensormatic oder eine andere
Quelle bezogen werden, wobei der
Anbieter den Nachweis der Konformität
bereitstellen sollte. Dies ist zur
Gewährleistung der elektrischen
Sicherheit des Produktes erforderlich.
2 of 10
8200-0181-04, REV. B