Pendant Shroud Installation - American Dynamics AD1273 CobraDome Installation And Operation Instructions Manual

INSTALLATION

Pendant Shroud Installation

This procedure applies only to pendant installations using the
pendant shroud. These instructions complete the pendant
mount installation procedure (refer to page 16, Pendant
Mount).
NOTE: Verify that the chassis, the lower dome, and the fascia
cover installation procedures are complete before
proceeding with the pendant shroud installation.
1) Attach the pendant shroud fascia plate to the chassis
housing with four 1/4-inch x 20 x 1-inch machine screws
(see Figure 19).
2) Loosen the hose clamp on the pendant mounting pipe and
lower the pendant shroud into place on the pendant shroud
fascia plate (see Figure 19).
NOTES: Leave the hose clamp snugly attached to the pendant
mount pipe for future servicing.
The original trim plate provided with the CobraDome
is not used with the pendant mount kit.
22
AD1273