American Dynamics IP SpeedDome Ultra 8 Installation Manual page 36

Installing IP SDU8 with a ROENDC End Cap
Check for bent
flange. Discard
housing if found.
Check for cracks
in bubble.
Discard bubble if
found.
5 Use the drive (taped inside bubble) to tighten the four tamper-proof screws on the bubble
assembly.
6 To compress the gasket evenly, tighten each screw in clockwise formation until slight
resistance is felt, then retighten each screw again in clockwise formation until all screws are
evenly tight.
Caution
If the network subnet is different from the default camera subnet of 192.168.1.80 then a laptop must be
directly connected to the camera in order to configure the network settings correctly.
7 Refer to the User Guide (8200-0885-02) for instructions on configuring the IP SDU8
configuration settings.
5-8
Once the bubble is attached to the housing, surface A
must meet surface B on all sides. Ensure lanyard is
not caught between flange and trim ring gasket, or
trim ring and sunshield.
A
B
Figure 5-16 Weatherproofing the IP SDU8
Ensure all four
tamperproof
screws are tight.
Installation Guide