2 Place the large hole at the end of the lanyard over the screw head of the bubble and pull its end
to snap it in place. Loop the lanyard to the inside of the housing.
3 Center the bubble over the dome housing and align its tabs with the mating tabs in the housing.
4 Turn the bubble clockwise until it catches the tabs and locks.
Caution
If the network subnet is different from the default camera subnet of 192.168.1.80 then a laptop must be
directly connected to the camera in order to configure the network settings correctly.
5 Refer to the Web Configuration Guide (8200-0885-02) for instructions on configuring the IP
SDU8 configuration settings.
Figure 3-10 Attaching the Lanyard
Figure 3-11 Attaching the bubble assembly
Figure 3-12 Locking the bubble
Installing IP SDU8 with an Indoor Hardmount
3-7