American Dynamics IP SpeedDome Ultra 8 Installation Manual page 20

Procedure 4-1 Describes how to assemble the IP SpeedDome Ultra Camera RHOPN pendant
mount.
Procedure 4-1 Assembly of IP SpeedDome Ultra Camera 8 RHOPN Pendant Mount
If mounting to a steel I-Beam, purchase I-Beam Mount RHIUIB.
1 To install the I-Beam Mount RHIUIB refer to instructions in the packaging then proceed to
step 6.
If mounting to a concrete ceiling, use the flange as a template.
2 Mark hole locations on ceiling.
3 Drill holes with the 6mm drill bit provided.
4 Install anchor hardware.
Figure 4-1 Assembly of flange and ceiling mounting
5 Attach anchor to ceiling using washers (A), lock washers (B), and nuts (C).
6 Cut four 30cm (12in) lengths of Teflon tape.
7 Holding nipple (A), tightly wrap a length of tape clockwise over its threads.
A
B
C
A
C
B
Figure 4-2 Assembly of the pipe tee section
D
4-2