American Dynamics SpeedDome Ultra 8 Quick Reference Manual page 9

The following screen appears during the initialization
process:
Init IO Flash Memory!
Initializing
Please Wait
Calibration
8.
4
•
This screen allows you to enter a password (135246)
to access the calibration screen shown below, which
enables you to define a zero reference point (or
target) from which all other camera targets will be
referenced.
Note: The Calibration feature is applicable to the
Outdoor Housing, P/N 0311-0124-xx, and the Indoor
Housing board, P/N 0312-3006-01.
Position Cross-hair
To Target 1
Press Focus Far
To Calibrate
•
Calibration is used only when replacing a dome in an
existing base.
•
The plus (+) sign in the middle of the screen is the
crosshair used for calibration.
SPEEDDOME ULTRA 8 CAMERA DOME CONFIGURATION UTILITY
QUICK REFERENCE GUIDE
CALIBRATION
PASSWORD:
0123456789
EXIT
+
Base IO Status
8.
5
BASE App Version: 2.30
BASE Boot Version 2.22
Temp:
Humidity:
Blower 1:
Blower 2:
Alarm Bits:
•
This screen displays the base IO operating
conditions and status.
•
The status information is automatically updated as it
changes.
Note: The Base IO Status feature is only applicable to
the Outdoor Housing board, P/N 0311-0124-xx.
Base IO Control
8.
6
Update App:
Blower Control: AUTO ON
Heater Control: AUTO OFF
•
This screen displays the base IO firmware version,
enables updating of the firmware, and enables
blower and heater control.
Note: The Base IO Control feature is only applicable to
the Outdoor Housing board, P/N 0311-0124-xx.
Dome Address Change
9
UPDATE DOME DATA FROM BASE
9 of 11
BASE IO STATUS
40.1 C
37 %
ON
ON
00
EXIT
BASE IO CONTROL
v2.30 => v2.30
EXIT
DOME ADDRESS CHANGED!!
CLEAR BASE DATA
8200-0600-02, REV. B