Information Messages - Husqvarna AUTOMOWER 435X AWD Operator's Manual

6.4 Information messages

The table below shows a number of information messages that may be shown in Automower
local Husqvarna representative if the same message appears often. For more information, refer to
33 .
Message Cause
Low battery
The product cannot find the charging station.
The battery is spent.
The charging station's antenna is defective.
Settings restored
Confirmation that
been carried out.
Guide 1/2 not found
The guide wire is not connected to the charg-
ing station.
Break in the guide wire.
The guide wire is not connected to the boun-
dary loop.
Connection changed New loop signal successfully changed.
Connection NOT Failed to change the loop signal.
changed
Slope too steep
The product stopped mowing because the
slope is too steep.
Poor signal quality
The Automower
product is assembled upside down, or the
product is tilted or upside down.
ComBoard SW must
The firmware in the Automower
be updated module needs to be updated.
50 - Troubleshooting
Reset all user settings has
®
Connect module in the
®
Connect
®
Connect. Contact your
Messages on page
Action
Change the position of the guide wire. Refer
To install the guide wire on page 24 .
to
Make sure that the charging station is instal-
led correctly. Refer to To find the charging
station on page 30 .
Replace the battery. Refer to
page 41 .
Check if the indicator lamp in the charging
Indicator lamp in
station flashes red. Refer to
the charging station on page 51 . This prob-
lem requires action by authorized service
technician.
This is normal. No action required.
Check that the guide wire's connector is
tightly connected to the charging station. Re-
fer to To install the guide wire on page 24 .
Find out where the break is. Replace the
damaged section of the guide wire with a
new loop wire and splice using an original
coupler.
Check that the guide wire is connected cor-
rectly to the boundary loop. Refer to
stall the guide wire on page 24 .
No action.
Create a new loop signal, try several times. If
the problem remains, the message requires
action by authorized service technician. Re-
To create a New loop signal on page
fer to
33 .
If this problem occurs frequently, change the
installation of the boundary wire to exclude
the steep part of the work area.
Make sure that the product is not upside
down or tilted. Speak to your authorized
service technician if the problem stays.
Speak to your authorized service technician
to get the firmware updated.
1404 - 006 - 05.01.2021
Battery on
To in-