Husqvarna AUTOMOWER 435X AWD Operator's Manual page 33

3.12.6.1 New loop signal
The loop signal is randomly selected to create a unique
link between the product and the charging station. In
rare cases, there may be a need to generate a new
signal, for instance if 2 adjacent installations have a very
similar signal.
To create a New loop signal
1. Put the product in the charging station.
Settings > Security > New loop signal in the
2. Select
app.
Create new loop signal .
3. Select
Save .
4. Select
5. Wait for confirmation that the loop signal has been
generated. This usually takes about 10 seconds.
3.12.6.2 To change the PIN code
1. Select Settings > Security > Change PIN code in
the app.
2. Enter the PIN code.
3. Enter the new PIN code.
4. Enter the new PIN code to confirm.
5. Make a note of the new PIN code in Memo. Refer
Introduction on page 3 .
to
3.12.6.3 Theft protection
Theft protection menu it is possible to set the
In the
alarm duration and also what events should trigger the
alarm. The factory setting is to require PIN code and the
alarm duration is 1 min.
Require PIN code
This function means that the product cannot be operated
or controlled after the STOP button has been pushed
without first entering the correct PIN code. If the
incorrect PIN code is entered 5 times, the product is
locked for a time. The lock is extended for each new
incorrect try.
Alarm duration
There is a possibility to set how long the alarm signal
should last. A setting between 1 and 10 minutes is
possible.
STOP button pressed
If the alarm "STOP button pressed" is enabled, the
alarm goes off if someone presses the STOP button and
the PIN code is not entered within 30 seconds.
Carried away
Carried away is enabled, the product senses
If the alarm
unexpected motions, and the alarm goes off.
To set the Theft protection
Settings > Security > Theft protection in the
1. Select
app.
2. Select the on/off button to enable or disable the
Require PIN code, STOP button pressed and
Carried away .
1404 - 006 - 05.01.2021
3. Move the horizontal bar to select the duration of
the alarm.
3.12.6.4 GeoFence
GeoFence is a GPS-based theft protection that makes a
virtual fence for the product. If the product is more than
a set distance away from the center position the product
will be deactivated and an alarm will start. The PIN code
is needed to deactivate the alarm and to start the
product again.
To set the center position and radius for the GeoFence
function
1. Select Settings > Security > GeoFence in the app.
2. Put the product in a central position of the work
area.
on/off button to enable or disable the
3. Select the
GeoFence function. The center position will be set
to the current position of the product.
4. Use the horizontal bar to set the radius.
®
3.12.7 Automower Connect (Bluetooth
only)
Automower ® Connect you can enable or disable the
In
®
Automower Connect module. You can also see the
signal strength, connectivity status, initiate new pairing
or remove the product from the paired accounts.
3.12.8 Messages
In this menu the previous fault and information
messages can be found. For some of the messages,
there are tips and advice to help to rectify the fault.
If the product is disrupted in any way, for example it is
trapped or the battery is low, a message is saved
relating to the disruption and the time it happened.
If the same message is repeated several times, this may
indicate that an adjustment to the installation or the
Installation on page 18 .
product is required. Refer to
®
Installation - 33