Husqvarna AUTOMOWER 435X AWD Operator's Manual page 21

Robotic lawn mower
Hide thumbs Also See for AUTOMOWER 435X AWD:
Table of Contents

Advertisement

> 1.5 m / 5 ft
0% - 50%
For slopes adjacent to a public road, put an
obstacle of minimum 15 cm / 6 in. along the outer
edge of the slope. You can use a wall or a fence
as an obstacle.
3.4.3.2 Passages
A passage is a section that has boundary wire on each
side and that connects 2 parts of the work area. The
passage must be a minimum of 2 m / 6.5 ft wide to get a
good cutting result. Short passages can be as narrow as
60 cm / 2 ft., if a guide wire is installed through the
passage. A long narrow passage can have a negative
impact of the cutting result.
Note:
If a passage is less than 2 m / 6.5 ft. wide,
install a guide wire through the passage.
The product always runs to the left of the guide wire as
seen facing the charging station. It is recommended that
the distance between the guide wire and boundary wire
is one third of the total width of the passage on the right
side and two thirds of the total width of the passage to
the left of the guide wire (A). The minimum distance
between the guide wire and the boundary wire is 30 cm /
12 in.
>60 cm / 24"
A dead end must be a minimum of 2.5 m / 8.5 ft. wide.
1404 - 006 - 05.01.2021
> 1.5 m / 5 ft
> 1.5 m / 5 ft
50% - 70%
>30 cm / 12"
3.4.3.3 To make an island
CAUTION:
Do not put a section of
boundary wire across the other. The
sections of boundary wire must be parallel.
CAUTION:
Do not put the guide wire
across the boundary wire.
CAUTION:
Isolate or remove obstacles
that are less than 15 cm / 6 in. in height.
Isolate or remove obstacles that slope
slightly, for example, stones, trees or roots.
This will prevent damage to the blades of
the product.
To make an island, isolate areas in the work area with
the boundary wire. We recommend to isolate all stable
objects in the work area.
Some obstacles are resistant to a collision, for example,
trees or bushes that are more than 15 cm / 6 in. in
height. The product will collide with the obstacle and
then select a new direction.
Put the boundary wire to and around the obstacle
to make an island.
>2 m / 7 ft
>2.5 m / 8.5 ft
Installation - 21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents