HP Envy 17 Maintenance And Service Manual page 58

NOTE: For touch screens, please update to the latest firmware after replacing the panel or touch control
board. More information can be found in Advisory: c06220255 - Download and Install the Touch Panel
Firmware During Service.
For the Dynamic Calibration (Color Calibration) feature, reload the calibration data after replacing the panel
kit. More information can be found in Advisory: c06640672 - HP Display Control Panel Color Calibration Data
Reload Process.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
Remove the display assembly:
Display panels are available as the following spare part numbers:
Full High Definition (FHD) antiglare, touch screen, UWVA, M45769-001
FHD antiglare, nontouch screen, AR UWVA, M45767-001
FHD antiglare, nontouch screen, UWVA, M45768-001
Ultra High Definition antiglare, nontouch screen, UWVA, M55014-001
1. Disconnect the antenna cables from the WLAN module (1), and then remove the webcam cable from the
clips that secure the cable (2).
2. Disconnect the webcam cable (3), and then disconnect the display panel cable (4).
3. Remove the webcam cable and the display panel cables from the clips that secure them (5).
50 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover and rubber feet on page
Battery on page 32).
31).
31).