Table of Contents
Advertisement
Do these:
•
Always follow all warnings and instructions that are marked on or supplied with the equipment.
•
Always use materials specifically designated for this product, the use of other materials may result in poor performance and create a
hazardous situation. Do not use aerosol cleaners, they may be explosive and flammable under certain conditions.
•
Always exercise care when moving or relocating equipment.
•
Always locate the machine on a solid support surface that has adequate strength to support the weight of the machine.
•
Always locate the machine in an area that has adequate ventilation and room for servicing.
•
Always unplug this equipment from the electrical outlet before cleaning.
Do not do these:
•
Never attempt any maintenance function that is not specifically described in this documentation.
•
Never remove covers or guards that are fastened with screws. There are no operator serviceable areas within these covers.
•
Never locate the machine near a radiator or any other heat source.
•
Never override or "cheat" any of the electrical or mechanical interlock devices.
Emergency Power Off
If any of the following conditions occur, turn off the scanner immediately and disconnect the power cable(s) from the electrical outlet(s).
•
The equipment emits unusual odors or makes unusual noises.
•
The power cable is damaged or frayed.
•
A wall panel circuit breaker, fuse, or other safety device has been tripped.
•
Liquid is spilled into the machine.
•
The machine is exposed to water.
•
Any part of the machine is damaged.
Maintenance Information
•
Any operator product maintenance procedures will be described in the user documentation supplied with the product.
•
Do not carry out any maintenance on this product which is not described in the customer documentation.
•
Do not use aerosol cleaners. The use of cleaners that are not approved may cause poor performance of the equipment, and could cause
a dangerous condition.
•
Use supplies and cleaning materials only as directed in this manual.
•
Do not remove covers or guards that are fastened with screws. There are no parts behind these covers that you can maintain or service.
•
Do not perform any maintenance procedures unless you have been trained to do them by an authorized local dealer or unless a
procedure is specifically described in the user manuals.
•
Never place this equipment where people might step on or trip on the power cord.
Advertisement
Table of Contents
Troubleshooting
