Table of Contents
Advertisement
Osc 1: the [osc sync] button
This button toggles Osc Sync on and off. You will know that Osc Sync
is enabled if the button is lit up. Pressing the button also immediately
takes you to Osc 1 Edit page 4 with the Sync Type parameter selected.
The Pre Filter section
Pre Filter Mix [edit]: Osc 1 Level
Page:
1
Soft Button:
1
Range:
0 – 100%
Default:
50%
This parameter is the first of the levels in the Pre Filter Mix, which
provides you a virtual mixing board for adjusting the strengths of the
Ion's various signal sources before they are sent to the filters. The Osc 1
Level parameter controls how much of Oscillator 1 will appear at the
inputs of the filters. This parameter can also be adjusted with the 1 knob
in the Pre Filter Mix section on the top panel.
Pre Filter Mix [edit]: Osc 2 Level
Page:
1
Soft Button:
2
Range:
0 – 100%
Default:
50%
This parameter controls the level of Oscillator 2 in the Pre Filter Mix. It
can also be adjusted with the 2 knob in the Pre Filter Mix section on the
top panel.
Pre Filter Mix [edit]: Osc 3 Level
Page:
1
Soft Button:
3
Range:
0 – 100%
Default:
50%
This parameter controls the level of Oscillator 3 in the Pre Filter Mix. It
can also be adjusted with the 3 knob in the Pre Filter Mix section on the
top panel.
Pre Filter Mix [edit]: Ring Mod Level
Page:
2
Soft Button:
1
Range:
0 – 100%
Default:
50%
This parameter controls the level of the Ring Mod source in the Pre
Filter Mix. Ring Mod is generated by multiplying the waveforms of
Oscillators 1 and 2. This parameter can also be adjusted with the ring
mod knob in the Pre Filter Mix section on the top panel.
Program Parameters
5
57
Advertisement
Table of Contents
