Table of Contents
Advertisement
Mod 2 Wheel Enable
Page:
5
Soft Button:
3
Range:
on, off
D efault:
on
When this parameter is set to on, the currently selected Part will respond
to the (m2) wheel and will send and receive its assigned controller
number information via MIDI. When set to off, the selected Part will
neither send nor respond to MIDI messages at its assigned controller
number.
Transpose
Page:
6
Soft Button:
1
Range:
-12 to +12 in chromatic steps
D efault:
0
This parameter allows you to transpose the selected Part up or down in
half-step increments over a total range of two octaves, independently of
the other Parts. In this way you can transpose one Part chromatically
without affecting the other Parts in the Setup.
Octave
Page:
6
Soft Button:
2
Range:
Range:
D efault:
0
With this parameter you can transpose the selected Part up or down in
octave increments over a range of 7 octaves, for a total range of 10
octaves (including the range covered by the keyboard). This allows you,
for example, to drop a bass by a couple of octaves and raise a brass
sound by an octave without affecting the other Parts in the Setup.
-3 to +3
Parts and Setups
The MIDI continuous controller numbers for
(m2) and the exp pedal are selected in the
Global parameter section. To select a
different value, go to Global Edit page 4,
Soft buttons 1 and 2, respectively.
NOTE: The settings of the Part Transpose
and Part Octave parameters will not change
the MIDI note output of the selected Part.
4
37
Advertisement
Table of Contents
