B Naming A Song - Alesis BRC Reference Manual

Note: Although the BARS Display Type is available for viewing (see
section 1.4C), this cannot be edited in the Set Song display. This is
because the song's starting position is referenced only to the
Normal tape position, and is always bar 1. When the Display type
is set to SMPTE, the song start will default to 00:00:00:00. However,
you can change the SMPTE offset associated with the song start
position. Changing the SMPTE offset in the Set Song display is the
same as using the SMPTE START OFFSET button (see section
5.0B0).
2. Use the Cursor buttons to position the cursor under the song
number, and use the Numeric Keypad or UP/DOWN buttons to
select the song number you want;
3. To edit the song name, use the NAME button (for more details,
see section 4.6B);
4. To edit the song start location (be sure you have selected
NORMAL Display Type), use the Cursor buttons to position the
cursor under the desired field, and use the Numeric Keypad,
UP/DOWN buttons, or the COPY TAPE LOCATION button to edit
the song start address;
Note: To use the COPY TAPE LOCATION button, it must be set to
Normal mode in the MIDI/UTIL section (see section 5.3F).
5. To fine tune the song location, press the Right Cursor button to
advance the cursor past the frame location (only accessible when
in NORMAL Display Type). This will access a second page which
allows for fine tuning the song start point;
The display will look like this:
S X X "SongName01"
fine tune +sf:ss
...where sf:ss is the fine tune amount in sub-frames and sample steps.
• Sub-frames are 1/100th of a frame, ranging from 0–99.
• Sample steps are divisions of sub-frames. Their range is 0–15.

4.6B Naming a Song

To edit the name of a song:
59