I Name Button; J Copy Tape Location Button - Alesis BRC Reference Manual

immediately change case.

1.4I NAME Button

This button is used to edit the names of Songs and Cues. When you
locate a Cue or Song, the name field in the display is not accessible
using the cursor buttons. To edit a name, you must press the NAME
button to select the name field. Pressing the NAME button will
always position the cursor at the first character of the name. Once the
name field is selected, the cursor buttons will function to select
individual characters within the name field or other displayed fields.
To edit a name:
1. Press the NAME button;
2. Use the cursor buttons to position the cursor under the character
to be edited;
3. Use the keypad buttons to change the value. While a name is
selected, repeatedly pressing a keypad button will cycle through its
numeric value and the characters shown on that key;
4. To select uppercase characters, press the UP button. To select
lowercase characters, press the DOWN button;
5. Press the NAME button again to store the name and return the
cursor to its original position.
Note: When editing locate names, an additional editing option is
available. If the NAME button is held down while using the
UP/DOWN buttons, a default set of 16 pre-stored names can be
scrolled through (such as "Verse A1", "Chorus 2", "Bridge", etc.).
These names can be edited, so that they represent the names that
you wish to use, such as "TurnArnd" (turnaround), "BreakDwn"
(breakdown), etc.
For more information about selecting and editing pre-stored names,
see section 4.1D.

1.4J COPY TAPE LOCATION Button

Pressing this button copies the currently displayed TAPE LOCATION
from the upper display into the lower LCD display for storing as a
locate point or song start position. This button has two modes
(Normal and Manual), which can be selected from by pressing the
MIDI/UTIL button repeatedly (see section 5.3F). In N o r m a l mode, the
11