Starting And Restarting Fst/Connect And Fireport 1394; Naming Things: Characters You Can Use; Naming Things: Forbidden Characters - Alesis ADAT-HD24 FirePort 1394 Reference Manual

3
Applications
Starting and restarting FST/Connect and
FirePort 1394
You may start and restart FST/Connect without turning off the
power to the FirePort 1394. But if you want to turn its power off
you should dismount the hard drive first using the taskbar tool, as
described on page 19, and then turn off the FirePort 1394.
But if you only go halfway by dismounting the FST drive without
shutting off the FirePort 1394, then when you start FST/Connect
again the program will display "No Drive Communication" in the
Drive Name window. You will not see any Project, Song, or Track
window information from the FST drive even though it has spun
up normally.
In order for everything to operate as it should once more, you'll
have to shut down the FirePort 1394, wait a few seconds, and then
turn it back on.

Naming things: Characters you can use

The following chart shows the list of characters that are available
to you when creating a name for a Drive, Project, or Song. Keep in
mind that file system 1.10 has an extended character set available
for use:
Letters and Numbers
Characters
Additional characters (1.10 only)

Naming things: Forbidden characters

There are some characters that you will not be allowed to use
when creating a name for a Drive, Project, or Song. The use of
these characters might cause conflicts with the file system, and if
you try to use them you will not be allowed to save the name until
you remove them or choose one of the allowable characters from
the chart above.
Here's the list of characters that are disallowed when creating a
name:
Illegal name characters
36
A-Z, a-z, 0-9
(space)
! # $ % & ' ( ) + , - . ; = [ ] ^ _ ` { } ~
\ / : * ? " < > |