Timer Recording - Aiwa XR-EM200 Operating Instructions Manual

Timer recording

Timer recording is available only for TUNER sources.
1 Hold down SHIFT and press TIMER on the remote
repeatedly so that "5" and "REC" are displayed.
2 Within 6 seconds, press ENTER.
"ON TIME" is displayed.
3 Press f or g to set the timer start hour,
and press ENTER.
4 Press f or g to set the minute, and press
ENTER.
"OFFTIME" is displayed.
5 Set the time to stop recording by following the
same procedure as steps 3 and 4.
6 Select the band and tune in the desired station.
7 Insert a recordable tape and then turn the unit
off.
"5" and "REC" remains in the display to indicate the
timer standby mode (when ECO mode is deactivated).
At timer-on time, the unit turns on and records the selected
source. After the specified timer-activated duration, the
unit turns off again.
•To stop timer setting in steps 1 to 4, press CLEAR.
Timer standby mode is also cancelled.
•The timer recording is not activated when the clock is not
set. ("SET NG" is displayed.)
•The timer recording will not begin unless the unit is turned
off first.
•Volume level is automatically set to 0 (minimum) when the
timer recording is activated.
To check the timer setting
Hold down SHIFT and press TIMER on the remote repeatedly
so that "PLAY" or "REC" appears in the display.
The timer-on time, the time to stop playback/recording and
the source are displayed for 6 seconds.
To change the timer setting
Reset the timer again.
To cancel the timer
Hold down SHIFT and press TIMER on the remote repeatedly
until "OFF" is displayed. "5" and "REC" disappear from
the display.
Tip:
Your timer setting is retained even if the timer is cancelled.
Next time the timer is activated, you can change your previous
setting, or simply use the same setting again.
Notes
•The timer playback performs every day at the specified time
unless you cancel it.
•You cannot set the same time for timer-on time and timer-
off time. "SET NG" is displayed if you do that. In this
case, reset the time.
•The timer playback will not begin unless the unit is turned
off first.
15