Timer Recording - Aiwa JAX-N5 Operating Instructions Manual

Timer recording

Turns on the unit and makes recording once at a specified time.
Timer recording is available only for TUNER source.
Use the remote from step 3.
1 Prepare the TUNER source.
Select the band and tune in to the desired station or tune
in to a preset station (see "Tuning in to preset stations").
2 Prepare the recording destination.
Insert the recordable tape in deck B.
3 Press CLOCK/TIMER/SET to display "DAILY
PLAY".
If "DAILY PLAY" is not displayed, set the clock (see
"Setting the clock") and carry out from this step again.
4 Press r or t repeatedly until "ONCE REC"
appears in the display and then press ENTER.
"REC 5" indicator lights up and "ON TIME" appears
for a moment.
5 Carry out step 4 to step 6 described in "Timer
playback" to set the timer-on time and timer-off
time.
The timer-on time, the timer-off time and source (TUNER)
are displayed.
6 Press POWER to turn the unit off.
The unit turns on at the specified timer-on time and records
the source (TUNER) and then turns off at the specified
timer-off time.
•To stop timer setting in step 3 to 4, press CLEAR on the
remote. Timer standby mode is also canceled.
•The Timer recording will not begin unless the unit is turned
off first.
•Volume level is automatically set to 0 (minimum) when the
Timer recording is activated.
•MULTI JOG is also available in place of r or t.
To display the timer setting
Press CLOCK/TIMER/SELECT on the remote repeatedly until
"ONCE REC" appears. The timer-on time, the timer-off time
and the source (TUNER) are displayed.
To change the timer setting
Re-set the timer again.
To cancel the timer
Press CLOCK/TIMER/SELECT on the remote repeatedly until
"TIMER OFF" appears. "REC 5" disappears from the
display.
Notes
•The Timer playback performs every day at the specified time
unless you cancel it. However, the Timer recording performs
only once: it automatically cancels itself when the recording
finishes.
•You cannot set the same time for timer-on time and timer-
off time. "SET NG" is displayed if you do that. In this
case, reset the time.
•You cannot select both the Timer playback and the Timer
recording at the same time. You must select either one with
CLOCK/TIMER/SELECT on the remote.
•When you use the sleep timer, the timer playback/recording
will not turn on the unit until the sleep timer turns it off.
En
21