Timer Recording; Care And Maintenance - Aiwa XR-M191 Operating Instructions Manual

To display the timer setting
Press TIMER.
The timer-on time, the source and the timer-activated duration
are displayed for 6 seconds.
Tip:
Timer setting can be displayed even while the unit is turned
off, and at that time if you press ENTER within 6 seconds after
TIMER is pressed, you can enter the timer setting mode and
change the setting.
To change the timer setting
Re-set the timer again.
To cancel the timer
Press TIMER repeatedly until "©) OFF" is displayed. "©"
disappears from the display.
Tip:
Your timer setting is retained even if the timer is canceled.
Next time the timer is activated, you can change your previous
setting, or simply use the same setting again.
16
REFERENCE
Timer recording
Timer recording is available only for TUNER and AUX/VIDEO
(with an external timer) sources.
1 Press either TUNER/BAND or AUX/VIDEO to
select a source.
2 Press TIMER repeatedly until "© REC" appears
on the display.
3 Carry out step 3 to step 5 described in "Timer
playback".
4 Prepare the source.
To record the radio, select the band and tune in to the
desired station.
To record external equipment conn the VIDE
AUX jacks, set an external timer for the equipment so that
its playback begins at the same time.
5 Insert the recording tape and then turn the unit
off.
Care and maintenance
Occasional core and maintenance of the unif and the software
are needed fo optimize the performance of your unit.
To clean the cabinet
Use a soft and dry cloth. If the unit surfaces are extremely
dirty, use a soft cloth lightly moistened with mild detergent
solution. Do not use strong solvents such as alcohol, benzine
or thinner.
To clean the tape heads
Dirty tape heads cause sound deterioration. After every 10
hours of use, clean the tape heads with a head cleaning
cassette. Refer to the instructions of the cleaning cassette.
To demagnetize the tape heads
Use a demagnetizing cassette after every 20 to 30 hours of
use. Refer to the instructions of the demagnetizing cassette.
Care of CDs
When a CD becomes dirty, wipe it from the center out with a
cleaning cloth. After playing a CD, store it in its case. Do not
keep it in hot or humid places.
Care of tapes
Store tapes in their cases after use. Do not leave tapes near
magnets, motors, television sets, or any source of magnetism.
Do not expose tapes to direct sunlight, or leave them in a car
parked in direct sunlight.
Resetting the unit
lf an unusual condition occurs in the display window or
the cassette deck, reset the unit as follows:
1 Press POWER to turn off the power.
Ifthe power cannot be turned off, disconnect the AC power
cord, then plug it in again.
2 Hold down Ml and press POWER.
Everything stored in memory after purchase is cleared.