Sony LIB-D81 Product Description Manual page 75

No. Flag
10 Autoloader
Temperature Limits
11 Autoloader Voltage
Limits
12 Autoloader Stray Tape
13 Autoloader Pick Retry
14 Autoloader Place Retry
15 Autoloader Load Retry
16 Autoloader door
17 Autoloader Mailslot
18 Autoloader Magazine
19 Autoloader Security
20 Autoloader Security
Mode
Type Required Host Message
C General environmental conditions inside the
autoloader are outside the specified temperature
range.
The autoloader supports this flag.
C The voltage supply to the autoloader is outside
the specified range. There is a potential problem
with the power supply or failure of a redundant
power supply.
The autoloader does not support this flag.
C A cartridge has been left in a drive inside the
autoloader by a previous hardware fault:
1.Insert an empty magazine to clear the fault.
2.If the fault does not clear, turn the autoloader
off and then on again.
3.If the problem persists, call the customer
service.
The autoloader does not support this flag.
W There is a potential problem with a drive ejecting
cartridges short or with the autoloader
mechanism picking a cartridge from a slot.
1.No action needs to be taken at this time.
2.If the problem persists, call the customer
service.
The autoloader does not support this flag.
W There is a potential problem with the autoloader
mechanism placing a cartridge into a slot.
1.No action needs to be taken at this time.
2.If the problem persists, call the customer
service.
The autoloader does not support this flag.
W There is a potential problem with a drive or
autoloader mechanism loading cartridges, or an
incompatible cartridge.
The autoloader does not support this flag.
C The operation has failed because the autoloader
door is open:
1.Clear any obstructions from the autoloader
door.
2.Close the autoloader door.
3.If the problem persists, call the customer
service.
C There is a mechanical problem with the
autoloader media import/export mailslot.
The autoloader does not support this flag.
C The autoloader cannot operate without the
magazine
1.Insert the magazine into the autoloader.
2.Restart the operation.
The autoloader does not support this flag.
W Autoloader security has been compromised.
door is open.
The autoloader does not support this flag.
I The security mode of the autoloader has been
changed.
The autoloader has either been put into secure
mode, or the autoloader has exited the secure
mode.
This is for information purposes only. No action
is required.
The autoloader does not support this flag.
Cause
Autoloader temperature limits
exceeded.
Autoloader voltage limits exceeded.
Stray cartridge left in autoloader after
previous |error recovery
Operating to pick a cartridge from a
slot had to perform an excessive
number of retries before succeeding
Operation to place a cartridge into a
slot had to perform an excessive
number of retries before succeeding
Operation to load a cartridge into a
drive had to perform an excessive
number of retries before succeeding
Changer door open prevents
autoloader functioning.
Mechanical problem with import/
export mailslot
Autoloader magazine not present
Autoloader door opened then closed
during operation
Autoloader security mode changed.
Chapter 8 SCSI Commands
75