Motorola ASTRO XTL 5000 Basic Service Manual page 100

8-6
1. To reassemble, ensure that all the keypads are fully seated into the front housing, and that all
the flexes (LCD Display module, volume and mode) will not be covered by the PCB. Ensure
that the GCAI seal is properly placed on the GCAI connector.
2. Place the PCB in the housing seating the PCB surface to the screw bosses. Ensure that the
aligning boss protrudes through the PCB. See
NOTE: Be careful not to pinch the flex for the LCD module and the volume switch flex
3. Plug in the three flexes.
4. Place the sealframe onto the PCB locating the "Top" is oriented correctly.
5. Using a Torx T10 screwdriver, fasten the 6 control head screws [15] following the sequence
as shown in
8.2.6 Transceiver Interface Board Disassembly/Reassembly
8.2.6.1 Mid Power Model Disassembly
1. Remove the two front panel TIB mounting screws using a Torx T10 screwdriver.
2. Grasp the front panel firmly, and pry off carefully using similar method as shown in
25. Unplug the flex from the radio side, then unplug the flex from the TUC side.
3. Remove the six screws that hold the remote interconnect board to the front panel using a Torx
T10 driver.
8.2.6.2 High Power Model Disassembly
1. To remove the front panel from the front of the radio, follow the disassembly procedure
outlined in
2. Place the front panel face down on a flat surface and remove the six interconnect board
retaining screws with a T10 Torx driver.
October 30, 2006
Disassembly/Reassembly Procedures: Replacement Procedures
assembly while pushing the board in place.
Figure 8-6 (torqued to 8 in. lbs).
section 8.2.7.2: High Power Models on page
Figure 8-7.
8-18, steps 1-6.
Figure 8-
6871769L01-A