Warranty Conditions; Disassembly And Disposal; General Sources Of Danger; Personal Protective Equipment - Bosch Rexroth IMScompact Position display Instructions Manual

4/18 Bosch Rexroth AG
2�3

Warranty conditions

The manufacturer guarantees the correct functioning of the process technology used and the specified
performance parameters.
2�4 Disassembly and disposal
If no return or disposal agreement was made, disassemble the device properly following the safety instructions
in these operating instructions, and dispose of it in an environmentally-friendly manner.
Before disassembly:
Switch off the power supply and protect it against being switched on again. Then, physically disconnect the
power supply lines and discharge any stored residual energy. Remove any operating and auxiliary materials
as well as remaining processing materials.
On disposal:
Recycle disassembled components: Metallic components to scrap metal, electronic components to electronic
scrap, plastic parts for recycling, dispose other components sorted by material quality.
CAUTION!
Environmental damage may occur if disposed incorrectly!
Electronic waste, electronic components, lubricants and other auxiliary materials are subject
to the treatment of hazardous waste and must only be disposed of by authorized specialized
companies!
Local authorities and waste management companies provide information on environmentally sound disposal.
Safety
NOTE!
Please read the operating instructions carefully before commissioning the device! Notes
on installation must be observed! Only commission the device if you have understood the
operating instructions. The operator must take and implement appropriate security-relevant
measures. Commissioning must only be performed by qualified personnel authorized and
instructed by the operator.
2�5

General sources of danger

This section provides an overview of important safety issues for optimum protection of personnel as well as
for secure and trouble-free operation. Failure to observe the action and safety instructions specified in these
instructions may lead to considerable dangers.
2�6

Personal protective equipment

In order to minimize health risks, wearing personal protective equipment is required when assembling the
device. Therefore: Before performing any work, put on the designated protective equipment properly and wear
during work. It is necessary to follow the signs for personal protective equipment attached in the work area.
Always wear the following when performing any work:
PROTECTIVE CLOTHING
... is close-fitting protective clothing with low tensile strength, tight-fitting sleeves and without
protruding parts. It serves primarily as protection from entanglement in moving machine parts.
Do not wear rings, necklaces or other jewelry.
PROTECTIVE GLOVES
... to protect the hands from abrasions, rubbing or similar superficial injuries of the skin.
PROTECTIVE HELMET
... to protect the head from injuries.
IMScompact position display | R320103179/2019-12