Setting Security Transmission - Muratec MFX-2500 Operating Instructions Manual

Performing batch transmission while using the
Note: The following instructions presume you are familiar with how to set and use
both your machine's autodialer and its batch transmission feature. If you
need to review, see pages 2.1–2.8 for more on the autodialer and/or pages
2.12–2.14 for more on batch transmission.
If you've specified Mode 1 or Mode 2
Important: Any autodialer number you use with batch transmission must include
the . (To review how to include this information in an autodialer
PIN
number, review the Mode 1 instructions under "Autodialling while
using the mask," page 2.46.)
PIN
Before sending a batch transmission the first time, you must store the
batch box. Here's how:
1
Follow the steps for creating or modifying a
batch box (page 2.12).
The asks for the fax number (here, we're
LCD
working with batch box 1):
2
Enter an autodialer number, or use the
numeric keypad to enter the fax number, to
which the batch transmission should go.
Important: If you're entering a number from the numeric keypad, enter the
fax number, followed by the * ("star") key and then the
3
Press [Enter] to save the setting.
Note: If you press [Enter] without entering the
indicates "No Number" on the
PIN
4
Continue with the steps for creating or modifying a batch box (page 2.12).
Now you can perform batch transmission to this box while the
mask
PIN
within its
PIN
.
PIN
, the fax machine beeps,
PIN
and then returns you to step 2.
LCD
mask is activated.
PIN

Setting security transmission

Your fax's security transmission feature provides extra assurance that your documents
go where you're sending them. When this feature is activated and your machine sends a
fax, the machine compares the last four digits of the dialled number to the other unit's
Subscriber (the phone number at the top of that unit's transmissions). If these digits
ID
match, your call goes through. If they don't, your machine disconnects the call and
prints an error message telling you to check the condition of the remote unit.
Before you activate this feature, consider:
• Not all fax machine owners enter their phone numbers in their Subscriber
Indeed, some machines don't even have a Subscriber
mission activated, your machine would disconnect its calls to such machines.
• Access codes can cause confusion. — If an autodialer entry ends with a long-distance
or other access codes, activating this feature prevents calls to that fax.
Note: In the following instructions, your fax's
1
Press , , 1, 0, [Enter].
MENU J
2
Select desired setting.
3
Press [Enter] to save the setting.
Beyond the Basics
s. —
ID
. So, with security trans-
ID
abbreviates Transmission as Tx.
LCD
2.47