Related Manuals for Johnson Controls CKM-F8P
Summary of Contents for Johnson Controls CKM-F8P
- Page 1 P2000 Security Management System hardware installation CKM-F8P power distribution module 24-10707-147 Revision C December 2017...
- Page 2 If this document is translated from the original English version by Johnson Controls, all reasonable endeavors will be used to ensure the accuracy of translation. Johnson Controls shall not be liable for any translation errors contained herein or for incidental or consequential damages in connection with the furnishing or use of this translated material.
- Page 3 Declaration of Conformity United States: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
-
Page 5: General Information
The CKM-F8P power distribution module provides eight zones of fused or PTC-protected power distribution with Fire Alarm Interface (FAI) control. The CKM-F8P accepts one or two DC power inputs, either of which are available on any output zone. Each output can be enabled for FAI, disabled for FAI, or set for continuous output. - Page 6 Description FlexIO Connectors These connectors pass the FAI and Fault signals to and from the CKM-F8P board and pass the FlexIO bus on to other accessory boards in the system. B1 Connectors (J1 Faston connectors for the B1 voltage bus in the system.
- Page 7 The FAI LED lights when FAI is active and an FAI input signal is (D11) – Red received from the FPO power supply. Optional Output When using the PTC version of the CKM-F8P, the fuse will be Fuses (F1 – F8) replaced with a soldered-in PTC. OUNTING...
-
Page 8: Wiring Information
For example, FlexIO from the power supply may be connected to either of the CKM-F8P’s FlexIO connectors, the Main DC voltage source may connect to either B1 terminal, and so on. WARNING: Risk of Electric Shock. - Page 9 24-10707-147 Rev. C Single Voltage with Eight Zones of FAI Controllable Distribution In this application, each zone output of the CKM-F8P may be set to provide 24 V of continuous output, 24 V enabled for FAI, or 24 V disabled for FAI. Because this is a single voltage system, only jumper positions 1-3 are valid.
- Page 10 Dual Voltage using Two Power Supplies with Eight Zones of FAI Controllable Distribution In this application, each zone output of the CKM-F8P may be set to provide 24 V of continuous output, enable on FAI, or disable on FAI. FAI control on the CKM-F8P is achieved by opening the NC contact on the power supply’s FAI input.
-
Page 11: Specifications
CKM-F8P Hardware Installation Manual 24-10707-147 Rev. C PECIFICATIONS The following table lists technical specifications for the CKM-F8P power distribution module. Item Specification Input (per Voltage: 12 or 24 VDC nominal +/- 15% bus) Current: 12A maximum Standby Current: 75 mA maximum Output (per Voltage: 11.1 to 12V or 23.4 to 24 V... - Page 12 CKM-F8P Hardware Installation Manual 24-10707-147 Rev. C...
- Page 13 Security Solutions (805) 522-5555 www.johnsoncontrols.com We welcome your comments at BE-techpubs-security@jci.com.