Sony Ericsson Z520a Working Instruction page 64

NOTE!
7. Carefully slide the flex connection of the camera
module into the slot in the adjacent edge of its
mating connector on the main flex film until the two
tabs on each side of the flex connection are butted
against the edge of the connector.
8. Rotate the black retaining bar into a horizontal
orientation. Then press down on the retaining bar
until it is completely closed.
NOTE!
•
Perform all sections of the Flip Reassembly
3/00021-1/FEA 209 544/597 B
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
Make sure that the main flex film
connector's black retaining bar is rotated to
vertical orientation before trying to insert
the camera module's flex film.
If there is a protective film over the small
display on the LCD assembly, remove it at
this time.
Working Instruction, Mechanical
64(113)