NOTE!
h. Lightly bend the flex film near the board
i.
j.
3/00021-1/FEA 209 544/597 B
©
Sony Ericsson Mobile Communications AB
To prevent damage to the flex film when
performing the next two steps, do NOT over
crease the bends being added to the flex
film.
connection end as shown.
Lightly bend the flex film near the vibrator
connection area as shown.
Remove the protective covering from the
adhesive film located on the main flex film that is
directly behind vibrator contacts.
Step-by-Step Instructions
Working Instruction, Mechanical
104(113)