Inner Base Cover - Sony Ericsson Z520a Working Instruction

2. Place a flip bumper strip between the two screw
bosses at the system connector end of the base cover
so that the two rubber bumpers on the bumper strip
insert into their corresponding holes in the inner base
cover.
3. Press the bumper strip down against the inner base
cover until the bumper strip is flush against the
surface of the inner base cover.
•
Perform sections 2.2.1-2.2.5 of the Base Reassembly
4.5

Inner Base Cover

Replacement Procedure
•
Perform sections 2.1.1-2.1.5 of the Base Disassembly
Tools needed to perform the following steps:
NOTE!
1. Obtain a new inner base cover and orient it so that
its inner surface is facing upward.
3/00021-1/FEA 209 544/597 B
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
A " * " beside a tool listed above indicates that the tool is not specifically called out in the
following instructions, but an operator may find it helpful to use that tool when performing some
steps of the following procedure.
Step-by-Step Instructions
Working Instruction, Mechanical
* Style 2A ESD tweezers
34(113)