Manual Control Settings - Trane Tracer AdaptiView Operation Manual

Equipment Settings

Manual Control Settings

Table 12, p.
Settings menu screen, along with their corresponding setting options. The chiller
configuration determines which of the settings appear.
Table 12. Manual Control settings menu screen: Buttons, available setting options, and status points
Feature
Compressor Control Signal
Evap Water Pump
Cond Water Pump
Clear Energy Consumption
Oil Pump
Clear Restart Inhibit Timer
Purge Exhaust Circuit Test
Purge Regen Cycle
44
44, lists the settings that are available as buttons on the Manual Control
Current value Available setting options
Auto/Manual Manual mode: Up/down
arrows for changing the
setpoint
On/Off • Auto
• On
On/Off • Auto
• On
XXXX kWh Clear
On/Off • Auto
• On
XX:XX min:sec Clear
Off/On • Auto
• On
Off/On • Auto
• On
Status points
IGV1 Position
IGV2 Position
Average Line Current
AFD Frequency
Active Chilled Water Setpoint (Active Hot Water
Setpoint if in Heating mode)
Evap Leaving Water Temp (Cond Leaving Water
Temp if in Heating mode)
Evaporator Pump Manual Override Time
Remaining
Evap Water Flow Switch Status
Active Chilled Water Setpoint
Evap Leaving Water Temp
Condenser Pump Manual Override Time
Remaining
Cond Water flow Switch Status
Active Hot Water Setpoint
Cond Leaving Water Temp
Oil Pump Manual Override Time Remaining
Oil Differential Pressure
Oil Pump Discharge Pressure
Oil Tank Pressure
Purge Rfgt Cprsr Suction Temp
Purge Liquid Temp
Carbon Tank Temp
Tracer AdaptiView Display Operations Guide • CTV-SVU01B-EN