Trane Tracer AdaptiView Operation Manual page 45

For water-cooled centravac chillers

Hide thumbs Also See for Tracer AdaptiView:

Table of Contents

To change a manual control setting, follow this procedure:

1. In the Equipment Settings column on the Settings screen, touch Manual Control

Figure 24. Manual Control Settings screen

2. Touch the button that shows the manual control setting you want to change. A screen

3. Touch the button that represents the setting you want. The button becomes shaded

4. To save your change, do one of the following:

CTV-SVU01B-EN • Tracer AdaptiView Display Operations Guide

Settings. The Manual Control Settings screen appears

for changing the manual control setting appears

and Apply and Save buttons appear at the bottom of the screen.

Note: The Compressor Control Signal screen provides up/down arrow keys and

numerical fields for selecting a value.

•

Touch Apply. The change is communicated to the Tracer UC800 controller. You can

observe the status points in the lower half of the screen change in response to the

setting change you just made. Also, a Manual Override button appears in the

upper left corner of the screen (see

•

Touch Save. The change is communicated to the Tracer UC800 controller. The

screen you were previously viewing appears.

(Figure

(Figure 25, p.

Figure 25, p.

46).

Equipment Settings

24).

46).

Table of Contents