Table of Contents
Advertisement
General Information
About This Manual
The step-by-step instructions outlined in this manual
describe the procedures required to successfully upgrade
an older Tracer™ CH530 DynaView equipped CVHE, CVGF,
CVHF, CVHG, CDHF, or CDHG CenTraVac™ chiller to a
Symbio 800 AdaptiView display system. This manual also
provides instructions and describes the procedures
required to upgrade a CH531 prebuilt panel retrofit-
equipped chiller to a Symbio 800 AdaptiView display
system.
Notice that the installation instructions in this manual are
divided into the following general topic areas:
1. Check the configuration and set-points in the
DynaView display.
2. Save the DynaView display configuration and set-
points.
3. Shut down power.
4. Remove the old control panel door.
5. Install new control panel door and Symbio 800
controller.
6. Choosing display arm mounting location.
7. Mount display arm and new display.
8. Install 1A2 power supply (if not already present).
9. Install 1A2 power supply on CH531 prebuilt panels.
10. Install quad relay output LLID (required if using chiller
control sequence 1).
11. Install communication cable between the 1A1 and 1A2
power supplies.
12. Connect input power wiring to the 1A2 power supply.
13. Routing new wire into and out of the control panel
enclosure.
14. Wiring connections to the Tracer AdaptiView display
and the Symbio 800 controller.
15. Before restoring system power.
16. Restoring system power.
17. Programming the Tracer AdaptiView display.
18. Full page schematic wiring diagrams.
CDUB-SVN001B-EN
Unit Model Number
For service purposes, Trane Model CDUB Symbio 800
AdaptiView display upgrade packages are assigned a
multiple character alphanumeric model number that
precisely identifies each unit.
An explanation of the identification code that appears on
the unit nameplate is shown below. Use of the service
model number will enable the owner/operator, installing
contractors, and service technicians to define the
operation, components and options for any specific unit.
Refer to the model number printed on the nameplate when
ordering replacement parts or requesting service.
5
Advertisement
Table of Contents
