Solid-State Drive - HP 240 G8 Maintenance And Service Manual

Table 5-7 Memory module descriptions and part numbers
Description
4 GB
8 GB
Before removing a memory module, follow these steps:
1. Prepare the computer for disassembly
2. Remove the rubber feet (see
3. Remove the bottom cover (see
4. Remove the battery (see
To remove a memory module:
1. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module.
(The memory module tilts up.)
2. Remove the memory module (2) by pulling it away from the slot at an angle.
Reverse this procedure to install a memory module.

Solid-state drive

To remove the solid-state drive, use this procedure and illustration.
Table 5-8 Solid-state drive descriptions and part numbers
Description
Solid-state drive, PCIe:
● 1 TB
(Preparation for disassembly on page
Computer feet on page
Bottom cover on page
Battery on page 28).
26).
27).
Component replacement procedures
Spare part number
L10598-855
937236-855
26).
Spare part number
L85370-005
35