Touchpad - HP 240 G8 Maintenance And Service Manual

1. Prepare the computer for disassembly
2. Remove the rubber feet (see
3. Remove the bottom cover (see
4. Remove the battery (see
To remove the touchpad click board:
1. Disconnect the touchpad cable (1) from the system board, and then disconnect from the touchpad click
board cable (2) touchpad.
2. Remove the two Phillips M2.0 × 2.0 screws (3) that secure the touchpad click board to the computer.
3. Lift the board, and then slide it outward from under the clips that hold it on place to remove it (4).
TIP: The edge of the board sits under clips. Be sure to slide the board out from under the clips to
prevent damage to the board or clips.
Reverse this procedure to install the touchpad click board.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-12 Touchpad description and part number
Description
Touchpad
Before removing the touchpad, follow these steps:
(Preparation for disassembly on page
Computer feet on page
Bottom cover on page
Battery on page 28).
26).
27).
Component replacement procedures
26).
Spare part number
L24484-001
39