Installing The Infeed System For 3Ra6 On A Level Surface (Screw Fastening) - Siemens SIRIUS 3RA6 System Manual

7.7.3.2

Installing the infeed system for 3RA6 on a level surface (screw fastening)

Requirements
● Drill holes with thread or plug on the level surface. For details of the distances between
the drilled holes, please refer to the relevant dimension drawing in "Dimension drawings
(Page 267)".
● Screws:
– Screw-type infeed (25/35 mm
– 3-slot extension module: Four M4 x16 screws incl. washers
– 2-slot extension module: Two M4 x16 screws incl. washers
– PE infeed: One M4 x 16 screw incl. washer
Procedure
Not only can the infeed system for 3RA6 be attached to a standard mounting rail, but it can
also be installed on a level surface using screws.
Note
Slots make the screw-type infeeds and extension modules easier to install. You can mount
and install the screw-type infeeds and extension modules using the slots on pre-assembled
screws.
Step
1
2
3
SIRIUS 3RA6 compact starter
System Manual, 09/2014, NEB560060102000/RS-AA/006
incl. washers
Instructions
Screw the 2 screws for the 2 slots into
the level surface.
Mount the screw-type infeed/extension
module on the pre-assembled screws.
Insert each of the remaining screws
through the relevant holes in the screw-
type infeed/extension module and screw
the device onto the level surface.
) or screw-type infeed (50/70 mm²): Five M4x16 screws
2
Image
Accessories
7.7 Infeed system for 3RA6
167