Remove The Camera Module - Fujitsu STYLISTIC Q7310 Manual

Remove the camera module

Required work steps:
■ Remove keyboard
■ Remove cradle
■ Remove pen
■ Removing the LCD back cover assy
■ Remove battery
■ Remove LTE module
► Put the gasket aside to the right (blue arrow).
► Disconnect the flexprint cables connected to the camera sub board (yellow circles).
The SAR antenna cable and the WWAN antenna cable run through the cable duct (yellow arrow) of the camera module.
►
► Disconnect the two SAR antenna cables (red rectangle) from the mainboard and lay them together with the yellow WWAN
antenna cable ("MAIN") outside the work area (green arrow).
Remove both M2XL3 screws (red circle).
►
Page 28 of 64
Required tools:
■ Screwdriver: Phillips, size PH00