Removing Network Ranges; Setting The Default Route Metric; Displaying Default Route Metrics - 3Com CoreBuilder 2500 User Manual

Removing
Network Ranges
Top-Level Menu
system
interface
ethernet
route
areas
fddi
arp
defaultRouteMetric
atm
display
multicast
interface
bridge
defineArea
udphelper
linkStateData
ip
modifyArea
routing
neighbors
ipx
removeArea
icmpRouterDiscovery
routerID
appletalk
addRange
ospf
partition
snmp
modifyRange
rip
stubDefaultMetric
analyzer
removeRange
ping
virtualLinks
script
statistics
statistics
logout
Setting the Default
Route Metric
Default
Displaying Default
Route Metrics
Top-Level Menu
system
interface
ethernet
route
areas
fddi
arp
defaultRouteMetric
atm
multicast
interface
bridge
display
udphelper
linkStateData
ip
define
routing
neighbors
ipx
remove
icmpRouterDiscovery
routerID
appletalk
ospf
partition
snmp
rip
stubDefaultMetric
analyzer
ping
virtualLinks
script
statistics
statistics
logout
This command removes a previously defined range.
To remove a range from an area:
1 From the top level of the Administration Console, enter:
ip ospf areas removeRange
2 Enter the address to remove.
3 Enter the IP address of the range to delete.
Example:
Select area {1-2}: 2
Enter IP address of range to delete: 158.101.0.0
The default route metric value indicates the cost for a default route. If the
cost is greater than 0, the router advertises itself as the default router to
the area.
The default metric value is 0, which indicates no advertisement.
Use this command to display the current default route metric value on
the router.
To display the default route metric, from the top level of the
Administration Console, enter:
ip ospf defaultRouteMetric display
A message indicating the cost for the route appears:
Default route metric = 1

Setting the Default Route Metric

13-5