3Com CoreBuilder 9000 Quick Start Manual page 18

18 Enterprise Management Engine Quick Start Guide
The
set interface
command
index
Configuring Access to the EME Using the RJ-45 Port
You can manage the chassis from a network management station (NMS)
that is connected to the EME RJ-45 port.
CAUTION: Do not change the IP address of an EME that is already up
and running from a network connection. Doing so will terminate the
session.
To manage the chassis from the NMS, assign IP connectivity values to the
EME using the commands in the following example:
CB9000> set ip ip_address 141.1102.3.131 ethernet_port
CB9000> set ip subnet_mask 255.255.0.0 ethernet_port
CB9000> set ip default_gateway 141.102.3.2 ethernet_port
You can now access the EME from the NMS. You can also send SNMP and
RMON requests to the EME.
If the interface does not function after a connection is made, use the
command to view the status of the interface. If the
show interface
interface is indicated as down, use the
to bring it up.
The
set interface index
Enable — You can enable the interface.
Disable — You can disable the interface.
set interface index
command options are:
command