3Com CoreBuilder 9000 Quick Start Manual page 15

Verifying an Interface
Initial Management
Access
If the interface does not function after a connection is made, view the
status of the interface using the
interface is indicated as down, bring the interface up using the
command.
interface index
The
set interface index
Enable — You can enable the interface.
Disable — You can disable the interface.
Examples:
CB9000> show interface
Idx Network Type State State Address
--- ------------- ----- ----- ----------------------------
2 serial_port SLIP DOWN
3 ethernet_portETH DOWN DOWN 08-00-8f-30-d6-69 17.02
To bring the ETHERNET (ETH) interface up, enter:
CB9000> set interface index enable
Initially, you access the system through the RS-232 serial port connector.
To communicate with the EME serial port after you successfully connect
to the RS-232 connector, configure your PC or terminal to the following
default settings:
9600 baud
8 data bits
no parity
1 stop bit
The following message appears on the terminal screen after you properly
connect a terminal to the RS-232 port:
CoreBuilder 9000 Enterprise Management Engine (vX.XX)
Copyright (c) 1999 3Com Corporation.
Login:
You can change the EME terminal settings after you successfully access
the module by entering the
Enterprise Management Engine Quick Start Guide
show interface
command options are:
Admin Oper MAC
DOWN N/A
set terminal console
15
command. If the
set
Slot
17.02
command.