3Com CoreBuilder 9000 Quick Start Manual page 13

Configuring the EME Table 4 lists the steps to configure the EME initially.
Configure your terminal to default EME communication settings. See your
terminal vendor's documentation.
Table 4 EME Configuration Steps
Procedure*
1 Configure your terminal to default
EME communication settings.
2 Configure EME Terminal Settings.
3 Configure the EME.
4 Set the time and date.
5 Set user login functions.
6 Set SNMP parameters to enable
network access.
* The order of configuration is important in some networks. Read the appropriate sections for
more information.
To gain access to the Administration Console of switching modules,
switch fabric modules, and interface modules, use the command:
connect <slot.subslot>
Enterprise Management Engine Quick Start Guide
Command
See your terminal vendor's
documentation
set terminal console hangup
set terminal console prompt
set terminal timeout system
set terminal timeout session
set eme contact
set eme diagnostics
set eme location
set eme name
set clock
set login password
set login administer
show login
clear login
set ip ip_address
set ip subnet_mask
set ip default_gateway
set community
set authentication
set eme trap_receive
13