Toshiba MMU-UP0091HP-E Service Manual page 228

No. Part name
Louver base 1) Remove screws for louver base.
n
assembly (2 pcs)
2) - ① Pull the upper part of the louver
base to upward.
2) - ② Take off the louver base by pull
out in the front direction.
<Attention for louver base assemble>
Insert the rib of the louver base into the
slot of back body same as the picture.
o Bell mouth 1) Remove screws for bell mouth. (4 pcs)
p
Drain pan and 1) Remove screws for drain pan. (2 pcs)
damper base
2) Remove screws for damper base.
(2 pcs)
Procedure
- 228 -
Remarks
Screws for louver base (2 pcs)
②
①
Back body slot
Louver base rib
Screws for damper base
(2 pcs)
Screw for drain pan
Screws for bell mouth
(4 pcs)
Screw for drain pan