Rear Fed Shower Fittings - Mira Activate Series Installation And User Manual

Installation: Rear Fed Shower Fittings
1
Trim the pipework back to the required
depth from the finished wall surface.
Remove all burrs and sharp edges.
3
Drill the fixing holes and fit the wall plugs.
Caution! Be aware of hidden pipes or cables.
Assemble the retaining disc, collet, seal retainer and small o-ring on to the pipe.
Slide over bracket and secure with 4 x screws supplied, by hand.
Insert large o-ring over bracket.
Important! Ensure arrow on backplate is oriented vertical as shown below.
25
90°
Retaining
Disc
Seal
Retainer
2
Disassemble the right angle connector
assembly and mark the locations of the
screw fixings.
Collet
O-ring
Bracket
Shroud
Note: O-rings supplied
in separate bag.
O-ring