Ceiling Fed Shower Fittings - Mira Activate Series Installation And User Manual

Installation: Ceiling Fed Shower Fittings
Fix at convenient height for all the family. Position the fittings so that water sprays down the
centre of the bath, or away from the opening of a shower cubicle. Water should spray away
from the user controller when the handshower is held on the slide bar.
1
Locate a suitable entry point in the
ceiling for the riser rail, avoiding joists
and services.
Position the slide bar assembly against
bathroom wall in desired position and
mark the centre of rail on ceiling.
The centre of the riser rail stands 45
mm from the wall.
Drill a hole in the ceiling that is a
minimum Ø30 mm maximum Ø40 mm.
Note: If the ceiling height is over
2.4m (8ft) a riser rail extension
kit will be required. Contact our
Customer Ser vice depar tment
to purchase a 550 mm riser rail
extension kit (Ceiling Fittings
Extension Kit - 1.1903.097).
Important! If supplied slide bar spacers are required, centre distance for ceiling
hole will increase to 70 mm from wall. This is to avoid ceiling joists if necessary.
Use the supplied longer fixing screws if you are using the spacers.
2
Insert the cable and the riser rail assembly
through the hole in the ceiling, ensuring the
user controller is at the desired height, the rail
is vertical, and that there is enough working
clearance above the top of the rail in the roof
space.
Caution! DO NOT allow any debris to block
the plastic pipe.
Caution! Be careful not to damage the cable
and connector on any sharp edges.
22
45 mm