Mounting The Topdresser - Toro Workman Topdresser 1800 Operator's Manual

2

Mounting the Topdresser

Parts needed for this procedure:
2 Attachment bracket
2 Clevis pin
4 Lynch pin
4 Cap screw (1/2 x 1 inch)
8 Flat washer
4 Locknut (1/2 inch)
2 Spacer mount
Procedure
Note:
On vehicles with serial numbers prior to
239999999, the Remote Hydraulic Control Kit (Model
07415) must be installed on the Workman before
installation of the TopDresser 1800.
Note:
An Engine Cover Kit, Part No. 99-1214 for
Liquid Cooled Gas Workman or Part No. 92-5963 for
Diesel Workman, must be installed on the Workman
to prevent material from overflowing directly onto the
engine.
1. Remove 2 flange-head cap screws and flange
locknuts securing rear of each engine frame
mounting bracket to each side of vehicle frame
(Figure 5).
Note:
If the Workman is equipped with a H.D.
Hitch Frame, the attachment mount brackets
(Steps 1 and 2) will already be mounted on
Workman. Proceed to step 3.
1. Engine frame mounting
bracket
2. Vehicle frame
Figure 5
3. Attachment bracket
2. Loosely secure a attachment bracket to each
engine frame mounting bracket and vehicle
frame with (2) flange-head cap screws and
flange locknuts previously removed
Note:
If the Workman is equipped with a H.D.
Hitch Frame, install the spacer mounts, steps
and 4, otherwise proceed to step 5.
3. Remove the cap screw, 2 flat washers, and
locknut securing each attachment bracket to
hitch frame tabs
1. Hitch frame tab
2. Vehicle frame
4. Secure a spacer mount to top of each hitch
frame tab with the cap screw, 2 flat washers,
and locknut previously removed
1. Spacer mount
g011382
5. Position the machine onto the vehicle frame,
aligning the holes in the rear mounting brackets
with the holes in each side of the frame
7).
8
(Figure
(Figure 6).
Figure 6
3. Attachment frame
(Figure
Figure 7
5).
3
g011391
7).
g011383
(Figure