Before Operation; Before Operation Safety; During Operation; During Operation Safety - Toro Workman Topdresser 1800 Operator's Manual

Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.

Before Operation

Before Operation Safety

•
The machine has different balance, weight,
and handling characteristics compared to some
other types of equipment. Read and understand
the contents of this Operator's Manual before
operating the machine. Become familiar with all
controls and know how to stop quickly.
•
Never allow children or untrained people to
operate or service the machine. Local regulations
may restrict the age of the operator. The owner
is responsible for training all operators and
mechanics.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
•
Know how to stop the machine and shut off the
engine quickly.
•
Check that operator-presence controls, safety
switches, and shields are attached and functioning
properly. Do not operate the machine unless they
are functioning properly.
•
Keep all shields and safety devices in place. If
a shield, safety device, or decal is illegible or
missing, repair or replace it before operating the
machine.
Note:
The front 1/3 area of the Workman cargo
zone must be covered by a 1/3 attachment or
shield when using the topdresser.
•
Tighten any loose nuts, bolts, and screws to
ensure that the machine is in safe operating
condition. Ensure that the machine components
are in place and secure.
•
Ensure that your vehicle is suitable for use with
an implement of this weight by checking with your
vehicle supplier or manufacturer.
•
Park the vehicle on a level surface, engage the
parking brake, shut off the engine, remove the key,
and wait for all movement to stop before leaving
the vehicle and the topdresser.

During Operation

During Operation Safety

•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long
hair, secure loose clothing, and do not wear loose
jewelry.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Do not operate the machine when tired, ill, or
under the influence of alcohol or drugs.
•
Ensure that there are not more occupants (you and
your passenger(s)) than the number of handholds
equipped on the machine.
•
Keep your hands and feet out of the hopper.
•
Remain seated whenever the vehicle is in motion.
•
Using the machine demands attention. Failing
to operate the vehicle safely may result in an
accident, tip-over of the vehicle, and serious injury
or death. Drive carefully, and to prevent tipping or
loss of control, do the following:
– Use extreme caution, reduce the speed, and
maintain a safe distance around sand traps,
ditches, water hazards, ramps, unfamiliar
areas, or other hazards.
– Reduce the speed of a loaded machine when
negotiating terrain undulations to avoid causing
the machine to become unstable.
– Watch for holes or other hidden hazards.
– Use caution when operating on a steep slope.
Travel straight up and down slopes. Reduce
speed when making sharp turns or when
turning on hillsides. Avoid turning on hillsides
whenever possible.
– Use extra caution when operating on wet
surfaces, at higher speeds or with a full load.
Stopping time increases with a full load. Shift
into a lower gear before starting up or down
a hill.
– Avoid sudden stops and starts. Do not go
from reverse to forward or forward to reverse
without coming to a complete stop.
15