Table of Contents
Advertisement
Important:
Ensure that the hoses are
routed away from any moving, sharp, or hot
components.
5.
Visually inspect the hydraulic system for leaks,
loose fasteners, missing parts, and improperly
routed lines. Make all repairs before operating.
Product Overview
Controls
Gate Metering Control
The black knobs on the left rear side of the machine
are used to adjust and lock the gate into the desired
open height position.
1.
Loosen the locking knob
allow it to slide freely in the slot.
2.
Set the gate knob
position and tighten the locking knob to secure
the adjustment.
Rate Scale
Use the rate scale
(Figure
flow rate. Refer to
Sand Application Rate (page
1. Gate adjusting knob
2. Gate locking knob
13
(Figure
19) enough to
(Figure
19) into the desired
19) to determine the desired
Figure 19
3. Rate scale
18).
g266287
Advertisement
Table of Contents
