Power Submenu - Planar LookThru LO552 User Manual

24.2 Power Submenu

Auto Power On

Set whether the system will automatically leave standby mode after AC power is
applied

Options: On, Off; Default: Off
Power Saving Mode

Set the action to take if there is no signal detected after the period of time selected
by the Power Saving Delay setting:

Disabled: The display will remain on even if no signal is present.

Low Power: The display will enter standby mode if no signal is detected after the
specified period of time.

Wake on Signal: The display will enter a reduced power mode if no signal is
detected after the specified period of time. When in this state, the display will turn
on when a signal is detected or when any key is pressed on the keypad or IR
remote.
Power Saving Delay

Set the number of minutes to delay before initiating the power saving mode action (if
any)

Options: 1 Minute, 5 Minutes, 15 Minutes, 30 Minutes, 60 Minutes; Default: 5
minutes
Power On Delay

Postpones startup by the set amount

Range: 0 to 10 seconds in 0.1 second increments
Planar LookThru Transparent OLED Display User Manual
020-1380-00D
Navigating Through the Menus
Page | 40