Planar LookThru LO552 User Manual page 12

recommended to be used for any installation. The Display Chassis is the part of the
display to use as a primary handhold during transport and mounting.
There are five secondary M6 mounting points on the underside of the electronic box.
These should only be used together with the primary mounting points on the Display
Chassis, but never by themselves. A counter weight is attached to the underside of the
electronic box in the
acceptable open space for ventilation on the underside of the display. Like the leveling
feet, it should be removed for a fixed mount installation, but provisions must be made for
the proper 5 mm inch spacing.
Note that the corners of the Display Chassis and the right side (viewed from the front) of
the electronic box are chamfered at a 45º angle, allowing a corner or right-angle
installation of Planar LookThru displays. This is a feature found in all the Planar LookThru
family of displays. The bottom view of a Planar LookThru in the figure below illustrates
the corner chamfers. The leveling feet and counterweight are also shown.
The backside of the electronic box also contains the controlling I/O for the display. This is
shown in the figure below. The power switch and power cord receptacle are centered on
the backside.
The keypad is described in detail in the "OSD Keypad" section on page 23. There are
four HDMI connectors consisting of two HDMI 2.0 compliant and two HDMI 1.4 compliant
inputs. Additionally, there is a DisplayPort 1.2 input and a corresponding DisplayPort
output. The RS-232 and LAN connectors are found on the right side of the electronic box
along with the jack for the remote sensor as well as USB-A and USB-B ports.
Planar LookThru Transparent OLED Display User Manual
020-1380-00D
Tour of the Planar LookThru Transparent OLED Product Family
Planar LookThru
. The counter weight also serves to create an
Page | 12